日本語
简体中文
繁體中文
A new energy-based lifting that brings the focused shortwave heating method once used in cancer treatment to skin lifting. Heat is concentrated in the lower dermis, where collagen is most abundant, so you can see a change in firmness right after treatment, even without anesthesia.
Alltite is a non-surgical lifting device developed by Innoxus that uses DLTD focused shortwave. Rather than putting heat in from outside the skin like radiofrequency, or placing dots in the SMAS layer like ultrasound, it uses dielectric heating designed so that temperature peaks in the mid-to-lower dermis, reducing the burden on the epidermis and pain while delivering strong energy to the collagen layer.
At Dr. NewCell we first check sagging and cheek volume while you are seated. If any of the concerns below applies to you, Alltite is the first option we consider.
Protect the epidermis, heat only the lower dermis
Skin firmness and fine lines are decided by the dermis (the collagen layer), two to three millimeters thick. Conventional lasers start at the epidermis and lose energy sharply as they go deeper, but after five years of research, Alltite was built so that temperature peaks in the lower dermis.
Radiofrequency is hottest at the epidermis, so even with cooling, heat reaches only the upper dermis. Ultrasound coagulates the SMAS layer in dots, which defines the line but does not make the skin itself firmer. Alltite peaks in the mid-to-lower dermis and sends little heat into the fat layer, so it builds firmness and lift together while keeping the risk of cheek hollowing low.
Thermal evidence
In the manufacturer's thermal-camera (FLIR) test, Alltite focused shortwave reached the 42 °C target temperature within 30 seconds and kept the whole treated area evenly heated throughout the treatment. Under the same conditions, conventional microwave stayed around 40 °C even after three minutes.
| Elapsed time | Alltite max | Alltite min | Microwave max | Microwave min |
|---|---|---|---|---|
| 30 s | 42.4 | 34.2 | 36.8 | 30.8 |
| 1 min | 43.1 | 38.2 | 39.2 | 31.7 |
| 2 min | 42.0 | 38.3 | 40.2 | 34.4 |
| 3 min | 42.9 | 38.5 | 40.2 | 33.2 |
| End of treatment | 41.7 | 38.3 | 40.7 | 35.1 |
One shot, sustained
On identical tissue set to 14.1 °C, we compared how the heat fades after one Alltite shot and after five seconds of stacked microwave exposure.
Why the dermis
Dermal collagen decreases by one to two percent a year from the mid-20s, falling to half of its 20s level in the 40s and about a third in the 60s. Fine lines, firmness, pores and texture are all decided in this layer, so a lift that only pulls the line does not bring the bounce back. Because Alltite puts its energy into exactly this layer, results show more clearly from the late 30s to the 60s, when aging has progressed.
Find yours
Even with the same Alltite, where the shots go, how many sessions you need and which treatments go with it change with your concern. Pick what bothers you most right now and we will show how Dr. NewCell designs Alltite for it. The final design is set together with the doctor, who looks at your face in person while you are seated.
Heat is concentrated in the collagen-rich mid-to-lower dermis to address firmness and the line together. The first course is three sessions two to four weeks apart, then maintenance once every six to twelve months.
Early sagging · from the dermisSee what to expect →Without anesthesia, the handpiece is kept in close contact and moved in a rubbing motion. If it feels hot, the rubbing speed is increased or the output is lowered right there. No sedation is used.
Feels like a warm stone massageSee the process →Little heat reaches the fat layer with this method. After checking cheek volume while you are seated, shots are concentrated on the sagging lines and the center of the cheek is passed over lightly.
Focus on sagging linesSee zone design →Bruising is rare, and you can wash your face and wear makeup the same day. Results are clearest two to three days later, once mild swelling settles, so we suggest scheduling it one to two weeks before the event.
Back to daily life the same daySee what to expect →Alltite lifts the overall line first, then fat-dissolving injections are added only to the deep cheeks, jowls and double chin where fat has dropped a lot. Alltite comes first.
Deep cheeks · jowls · double chinSee combinations →Ultherapy covers the SMAS and Alltite the dermis. Spreading one Ultherapy session and three Alltite sessions across the year complements different layers and makes results last longer.
SMAS + dermis, complementing different layersSee combinations →These are example designs by concern, not a diagnosis. The number of shots, sessions, spacing and any combined treatments are decided in consultation after looking at your skin.
Radiofrequency · Ultrasound · Focused shortwave
Dr. NewCell has Thermage FLX, Ultherapy Prime, XERF and Alltite. Not to sell any one of them, but to design the combination according to which layer is sagging and how much cheek volume you have.
Device characteristics are based on manufacturer data and general operating principles; results and pain vary with each person's skin condition and treatment design. Which device suits you is decided in a consultation with the doctor, after checking the sagging layer while you are seated.
Short-term and long-term results come together
A single session starts both an immediate heat contraction (tightening) and collagen regeneration over several months.
Immediate contraction of dermal collagen tidies the line. There may be redness for about an hour.
As mild swelling, like the day after eating salty food, settles, firmness and lift become distinct.
Fine lines smooth out and the skin stays taut. Completing three sessions two to four weeks apart extends this period.
Newly made collagen keeps the skin healthier and firmer until it decreases again with aging.
Alltite for a sagging face
Changes in patients from their 30s to 50s, right after treatment and two weeks later. All photos were taken under the same lighting and from the same angle, and are unretouched.
Results may differ depending on each person's skin condition and lifestyle, and the cases above do not appear the same way in every patient. Photos: Innoxus clinical cases, published with patient consent.
Firmness and sagging: Alltite. Fat: NewCell Fit.
The design principle is simple. Alltite takes care of firmness and the line, and NewCell Fit fat-dissolving injections take care of areas where volume remains. Alltite always comes first.
Alltite lifts the overall line first, then fat-dissolving injections are added only to the deep cheeks, jowls and double chin where fat has dropped a lot. Lifting the line first keeps the contour neat after fat dissolving, so the two are planned together.
Alltite fills in dermal collagen, and expression lines and texture are finished with Skin Botox or Rejuran. You have Alltite first and continue with the rest afterwards.
Ultherapy covers the SMAS and Alltite the dermis, so they complement different layers. Combining one Ultherapy session and three Alltite sessions a year makes results last longer and keeps the immediate lift going.
Alltite first lifts the sagging above the fold naturally, and only the groove that still remains gets a very small amount of filler. Lifting the sagging first means less filler is needed for a natural-looking line. Areas with filler get Alltite three months later.
Process
With Alltite, area-by-area design matters. Which areas to treat, how much, and where to pass lightly are planned carefully for each face. That is why the doctor handles everything in person, from consultation to the post-treatment check.
Doctors with 16 years of experience check the sagging layer (dermis, fat, SMAS) and cheek volume while you are seated. There are no consultations with sales coordinators.
To prevent cheek hollowing, sagging lines are focused on and the center of the cheek is kept light. Designed within 400–600 shots per half face at 110–150 W.
Without anesthesia, the handpiece is kept in close contact and moved in a rubbing motion. If it feels hot, the rubbing speed and output are adjusted right away. No sedation is used.
We check the immediate change together in the mirror and decide on the next session in two to four weeks and whether to add a combination treatment.
Aftercare
FAQ
For international patients
Alltite is a non-surgical DLTD lifting with no anesthesia and no bruising, so you can have it during a short Seoul trip and fly home the next day. English- and Japanese-speaking consultation, price list before you fly, right next to Sinnonhyeon Station (exits 5 and 6).
オールタイトは麻酔・内出血なしのDLTDリフティング。3日間の韓国滞在中でも受けられ、翌日帰国できます。日本語相談・事前料金案内可。
Address: 7F Namyoung Bldg, 458 Gangnam-daero, Gangnam-gu, Seoul — Dr. NewCell Clinic Gangnam
Line 9: from Sinnonhyeon Stn. exit 5, walk straight; 7F of the building right next to the Apple Store
Shinbundang Line: Sinnonhyeon Stn. exit 6, on your left; 7F of the building between Starbucks and the Apple Store
About 8 min walk from Gangnam Stn. (Line 2) exit 11
*Parking: free parking for patients visiting Dr. NewCell Clinic
Medical director Dr. Shin Yong-bae · 16 years in anti-aging · medical team of 9
Alltite consultations are done by the doctor in person. If you booked at an event price, that price stands.
The information on this page does not replace a consultation with a doctor. Results and side effects vary by person, and side effects such as redness, swelling and a feeling of heat may occur. Before-and-after photos are published with patient consent and are unretouched. The device comparison information, the heating-principle animation and illustrations, and the video at the top are materials from the manufacturer (Innoxus); the person in the videos appears in the manufacturer's brand film and is not a promotional model for Dr. NewCell Clinic. Dr. NewCell Clinic · Business reg. no. 380-22-01983.
